Job was saved successfully.
Job was removed from Saved Jobs.

Innerspring Clip Assembler - 2nd Shift


Last Updated: 7/07/21

Job Description


The main function of this job is to pre-attach the border wires to the innerspring and to serve as a quality inspector prior to packaging. The work hours are 2:30pm-10:30pm Mon-Fri.

Essential Duties and Responsibilities:

  • When an innerspring comes off the machine, the pre-clip inspector must do any repair and trim work that is needed using a small cutting pliers.
  • Border wire is then attached to the outside of the innerspring unit. This is done using an air powered clip gun.
  • After clipping four corners of the innerspring, the innerspring is then lifted to an overhead carrier.They must be lifted approximately 18 โ€“ 24โ€ off the ground. The smaller and lighter innerspring must be lifted a little higher than 24โ€.
  • Depending on the size of the innerspring this cycle could be repeated as often as every two-three minutes.
  • If you are assigned to just one machine the units must be clipped all the way around.

Minimum Requirements:

High School diploma/GED helpful but not necessary


No previous experience is required.

Company Details

Hickory, North Carolina, United States